• select the fixtures to be distributed.
• Use UP button to select relevant channel number, and press DOWN to select the
channel number to be distributed.
• Press RECORD button to confirm, and press ESC button to cancel or exit.
7. 5 PAN / TILT FADE ONLY
• Enter the setting mode to choose item 3. P/T FADE ONLY , and press the RECORD
button to enter “PAN/TILT FADE ONLY” mode.
Further information will be shown on the LCD:
FIXTURE1: ONLY
OK ESC SEL ADJ
• Select
fixtures by the UP button, and press the DOWN button to select “FADE ONLY”
or ”FADE ALL”.
• Press “RECORD” to confirm your operation, and “ESC” to cancel or exit.
7. 6 Display mode (100/255)
• Enter the setting mode and choose item 4. DISPLAY MODE , then press the
RECORD button to enter.
LCD will show you:
DISPLAY MODE : ×××
OK ESC CHANGE
• Select mode100 or mode255 by UP/DOWN buttons.
• Press “RECORD” to confirm your operation, use “ESC” to cancel or exit.
7. 7 MIDI channel
• Enter the setting mode and choose 5. MIDI CH. , then press RECORD button to
enter the relevant further operation. LCD will show you:
MIDI CH. <××>
OK ESC CHANGE
• Select relevant MIDI channels(1-16) by UP/DOWN buttons.
• Press “RECORD” to confirm your operation, and use “ESC” to cancel or exit.
8 Notice for CF card
• Do not pull out the CF card when being used.
• Power must be assured “on”, when reading or storing to CF card.
• Turn off the power when connect or disconnect CF card with the unit.
• CF
card (32M) can be used only for NEMESIS 136, otherwise the data would probably
be missing.
13
To Next Page
Loading...
