ENGLISH
5
RECORD
14 32
RECORD
REC
CLEAR
STEP
DELETE
RECORD
REC
EXIT
Erase All Programs
Clear a Scene or Scenes
Delete a Step or Steps
1 . Press and hold the Record button.
2 . Tap the Flash button 1, 4, 2 and 3 in sequence while holding the Record button.
All LEDs will flash, indicating all programs stored in memory have been erase.
1 . Record enable.
2 . Record a scene or scenes.
3 .
If you are not satisfied with the scene or scenes, you may tap the
Rec Clear button while pressing and holding the Record button,
all LEDs will flash, indicating the scenes have bee cleared.
1 . Enter the Edit mode.
2 . Tap the Step button to scroll to the step you wish
to delete.
3 .
Tap the Delete button when you reach to the step you
wish to delete, all LEDs will flash briefly indicating the
deletion of the step.
4 . Continue steps 2 and 3 until all the unwanted step have been deleted.
5 .
Tap the Rec Exit button while pressing and holding down the Record
button, the Scene LED goes out, indicating the exit of Edit mode.
To Next Page
Loading...
Need help?
General
