ENGLISH
2
RECORD
16 86
MODE
SELECT
CHNS SCENES
A DOUBLE
PRESET B
1 - 48 SINGLE PRESET
Begin Programming
Record Enable
1 . Press and hold down the Record button.
2 . While holding down the Record button, tap the Flash button 1,6,6 and 8 in
sequence.
3 . Release the Record button, the Record LED lights up, now you can begin
programming your chase patterns.
NOTE :
The first you turn on your unit, the default setting of the Record Code is Flash
buttons 1, 6, 6 and 8.
Security for Your Programs
To protect your programs from any editing by others, you may change the Record
Code.
1 . Enter current Record Code (Flash buttons 1, 6, 6 and 8).
2 . Press and hold down the Record and Edit buttons at a time.
3 . Wkile holding the Record and Edit buttons, tap the desired Flash button to
enter a new Record Code.
4 . Enter your new Record Code a second time, all channel LEDs and scene
LEDs will flash three times, now the Record Code is changed.
5 . Exit Record mode. Tap the Rec Exit buyyon while pressing and holding dow
the Record button, release the two buttons at a time, the Record mode is
disengaged.
Program Scenes
IMPORTANT
Always remember to exit Record mode when you won't continue your programming,
otherwise you may lose control of your unit.
NOTE :
The second time you enter new Record Code different from that of the first time, the LEDs will not flash, which
means you've failed to change Record Code.
When you've entered a new Record Code the first time, and you want to cancel the new Record Code, you may
press and hold down the Record and Exit buttons at a time to exit.
1 . Record Enable.
2 . Select the 1 - 48 Single mode by tapping the Mode Select
button.This will give you control of all 48 channels as you
program. Be sure that Master A & B are both set at maximum.
(Master A is at its maximum in the fully up posiition, while
Master B is at its maximum in the fully down position)
To Next Page
Loading...
Need help?
General
