ENGLISH
7
Running Chase Programs
PAGE
1234
MODE
SELECT
CHNS SCENES
A DOUBLE
PRESET B
1 - 24 SINGLE PRESET
0
2
4
6
8
10
0
2
4
6
8
10
MASTER
MIN
MAX
MAX
MIN
A
B
Running a Program To Audio
AUDIO
0
2
4
6
8
10
0
2
4
6
8
10
AUDIO LEVEL
Running a Program With the Speed Slider
SPEED
.1 SEG
.2 S
.5 S
1 S
2 S
5 S
10 S
30 S
1 MIN
2 MIN
5 MIN
MINS
SHOW
MODE
.1 SEG
MINS
SHOW
MODE
10 MIN
1 MIN
2 MIN
5 MIN
20 S
10 S
5 S
2 S
1 S
.5 S
1 . Tap the Mode Select button select
mode indicated
by the red LED.
CHNS SCENES
2 . Tap the Page button to select the correct
page the program you wish to run is located.
3 .
Push Master Slider B to its maximum position
(fully down).
4 .
Move the desired Channel slider (25 - 48) (* 13 - 24) to its
maximum position to trigger the program, and the program
will fade in depending upon current fade time.
You may press and hold down the relevant Flash button
(25 - 48) (* 13 - 24) to trigger the program.
5 .
Move the Channel slider to adjust output of the current
program
1 .
Use built-in microphone or plug the audio soude
into the RCA Audio jack.
2 .
Select your program as described above.
3 .
Tap the Audio button until its LED lights, indicating
Audio mode is active.
4 .
Use the Audio Level slider to adjust the music
sensitivity
5 .
To reurn to normal mode, tap the Audio button a
second time causing its LED goes out, the Audio
mode is disengaged.
1 .
Be sure the Audio mode is disengaged, thast is, the
Audio LED goes out.
2 .
Select your program as described above.
3 .
Move the Speed slider to the SHOW MODE position
( the bottom), then tap the Flash button (25 - 48)
(*13 - 24) while pressing and holding down the Rec
Speed button, the corresponding program will not run
with the Standard beat any longer.
4 .
Now you may the Speed Slider to select your desired
speed
The step 3 is not necessary if the selected program is
not recorded with Standard Beat.
NOTE:
AUDIO
0
2
4
6
8
10
0
2
4
6
8
10
REC SPEED
FLAHS 25 - 48
(*FLAHS 13 - 24)
To Next Page
Loading...
Need help?
General
