EasyManuals Logo

Workshop WS1600SS User Manual

Workshop WS1600SS
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
OPERATION
To reduce the risk of electric shock, this
appliance has a polarized plug (one blade
is wider than the other). This plug will fit
in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a
qualified electrician to install the proper
outlet. Do not change the plug in any way.
After you plug the power cord into the
=
OFF
=
ON
WARNING: To reduce the risk of fire, explosion, or damage to Vac:
Do not leave Vac running while unattended - you may fail to notice important
signs indicating abnormal operation such as loss of suction, debris/liquid
exiting the exhaust, or abnormal motor noises. Immediately stop using Vac
if you notice these signs.
Do not leave Vac plugged in when not in use.
Do not continue running when float has cut off suction.
Sparks inside the motor can ignite airborne flammables. Do not operate Vac
near flammable liquids or in areas with flammable gases, vapors, or
explosive/airborne dust. Flammable liquids, gases, and vapors include:
lighter fluid, solvent-type cleaners, oil-based paints, gasoline, alcohol, and
aerosol sprays. Explosive dusts include: coal, magnesium, aluminum,
grain, and gun powder.
Do not vacuum up explosive dusts, flammable liquids, or hot ashes.
WARNING: To reduce the risk of electric shock or injury:
Do not expose to rain or allow liquid to enter motor compartment. Store
indoors.
Do not handle plug, switch, or Vac with wet hands.
Unplug Vac before servicing. If your Vac is not working as it should, has
missing parts, has been dropped, damaged, left outdoors, or dropped into
water, return it to an independent service center or call customer service.
When using an extension cord, use only outdoor-rated cords that are in
good condition. Do not allow the connection to come into contact with
liquid.
!
!
outlet, turn the unit on by pushing the
switch from position "O" to position "l". The
symbols used on the switch actuator are
international "On & Off" symbols.
SP6851-1 Workshop :SP6439-3_ES.qxd 9/20/13 11:58 AM Page 11

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Workshop WS1600SS and is the answer not in the manual?

Workshop WS1600SS Specifications

General IconGeneral
BrandWorkshop
ModelWS1600SS
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals