Workshop WS1600SS User Manual

1. Locate blowing port of your Vac.
2. Insert the locking end of the Dual-
Flex™ Locking Hose into the blowing
port of the Vac. The hose should snap
into place. To remove the hose from the
Vac, press the release button in the
hose assembly and pull the hose out of
the Vac inlet.
3. (Optional) Attach extension wand to
opposite end of hose, then place the
car nozzle on the wand.
4. Turn Vac on and you are ready to use
your Vac as a Blower.
Car Nozzle (Optional)
Dual-Flex
Locking
Hose
Blowing
Port
Extension
Wand
(Optional)
Swivel
End of
Hose
OPERATION (continued)
13
1. The Vac comes equipped with a drain
for easy emptying of liquids. Simply
unscrew the drain cap and lift the
opposite side slightly to empty the
drum.
2. Another option is to remove the
powerhead assembly and dump the
drum contents into the proper waste
disposal container.
WARNING: To reduce the risk of
back injury or falls, do not lift a Vac
heavy with liquid or debris. Scoop
or drain enough contents out to
make the Vac light enough to lift
comfortably.
Emptying the Drum
!
Blowing Feature
Your Vac features a blowing port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a blower.
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a Blower.
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
!
!
!
!
SP6851-1 Workshop :SP6439-3_ES.qxd 9/20/13 11:58 AM Page 13

Workshop WS1600SS Specifications

General

Brand	Workshop
Model	WS1600SS
Category	Vacuum Cleaner
Language	English