Handling
USA
15
After inserting the
battery, the caliper
will need approxi-
mately 5–6 seconds
to configure itself. The
caliper may only be
switched on once the
configuration process
is complete.
Handling
1. Push the OFF/ON button
13
to
switch the caliper
1
on.
2. To select the desired unit of mea-
sure (metric/inch), push the mm/
inch button
7
.
The caliper saves the
set unit of measure
for the next time you
use it.
3. Set the caliper to 0 by pushing
the ZERO button
12
in order to
start the measurement. For ad-
ditional functions of the caliper,
refer to the chapter “Functions”.
4. Move the slider
9
or turn the
fine adjustment dial
11
to per-
form a measurement.
To Next Page
Loading...
