Functions
USA
16
You can lock the caliper
with the locking screw
6
to fix the result of
the measurement.
5. Read the result of the measure-
ment on the LCD display
5
.
6. Push the OFF/ON button to switch
the caliper off.
Functions
Zero setting
The zero setting can be performed
in any position and facilitates step
measurements
15
.
− Push the ZERO button
12
to
set the zero point. This makes it
possible to perform differential
measurements.
Negative measure-
ments are displayed
with a “–”.
Conversion
The mm/inch conversion may be
performed in any position.
− To display the result of the mea-
surement in another unit, push
the mm/inch button
7
.
To Next Page
Loading...
Need help?
General
