Take Off
Transmitter Flight Controls
1. Activate the rotors by pushing the left stick to the lower right corner and hold it
for 3 seconds.
2. While the rotors are spinning, push the stick up slowly to take off, put the stick
back in the middle position afterward to hover in place. Tapping will also make
the drone ascend to 15 feet high and hover in place autonomously.
Notes:
1. The red LEDs indicate the front of Recon. Always be aware of the orientation during fly. Pressing and
holding
can turn off the front red LED lights.
2. Slowly move the sticks to avoid sudden or unexpected changes of position.
When the left stick is back at the center, the drone will hover at its current position.
Notes:
If the pilot doesn’t make the drone take off within 6 seconds after the motors are activated, the rotors will
shut down and be locked.
1. To make the drone ascend,
push the left stick up.
2. To make the drone descend,
pull the left stick down.
3. To make the drone rotate left,
push the left stick to the left.
4. To make the drone rotate right,
push the left stick to the right.
5. To make the drone move forward,
push the right stick up.
6. To make the drone move backward,
pull the right stick down.
7. To make the drone move to the left,
push the right stick to the left.
8. To make the drone move to the right,
push the right stick to the right.
15ft.
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
Transmitter Operations Cont.
To Next Page
Loading...
Need help?
General
