Initialized
00:00:00
00.0m 00.0m
6
Preparing for Flight using the Transmitter
1. Place Recon on a flat stable surface and turn on the drone by pressing & holding
the power button on the battery pack. The drone will immediately start the flight
system check and gimbal system check when the front red LEDs turn on and the
rear blue LEDs quickly blink.
2. When the rear blue LEDs slowly blink and the drone makes a beep sound, this
indicates that the flight system check is complete.
3. When the gimbal is level, facing down, and the drone makes a second beep
sound, this indicates that the gimbal is ready.
4. Turn on the transmitter by pushing up the power switch. In a few seconds the
transmitter will connect to the drone when the screen enters the control interface.
5. Wait until the drone gets a GPS signal strength of at least 6 and the screen
displays a icon before take off. If the satellite signal strength is not stable, try it
in another area.
Warning:
1. Do not touch or move the drone while it is system checking.
2. If the drone is idle for 10 minutes with the power on, it will begin emitting an alarm sound.
To stop that sound, turn off the battery.
ON
OFF
1. 4.
5.
Notes:
Only one control device may be connected to Recon at any time. Do not attempt to pair the Smart Watch
once the Transmitter as been connected. Doing so may result in the drone malfunctioning and
possibly crashing.
Transmitter Operations Cont.
Flight Height
Recon GPS Strength
Time
Recon Battery Level
Ready to fly
Transmitter Battery Level
Rotors Locked
Distance
To Next Page
Loading...
Need help?
General
