HANGZHOU WORLDE DIGITAL PIANO CO.,LTD HANGZHOU WORLDE MUSIC ELECTRONIC CO., LTD
WEBSITE: WWW.WORLDE.COM.CN EMAIL:SALES@WORLDE.COM.CN TEL:86 571 88730848
- 11 -
5.1.3.2 Select the MIDI note number: Snare
Setting Pad 2 to trigger the snare is done the same way, only by choosing a different MIDI note number (38 in this
case):
So now you’re ready to lay down the groove for your song: You have Pads 1 and 2 set to play the Kick and Snare, and
Pads 7 and 8 set to Stop and Start the song.
5.1.4 Assign a Pad to toggle a MIDI CC # between two values
One popular musical effect these days is to take an audio loop, filter it heavily for certain sections of a song, and switch
it back to the full-open sound later in the song. You can pre-configure one of the MINI pads to send those commands to
a filter plug-in that should be readily available in your DAW software.
We’ll use Pad 6 for this example. Select it and then use the pull-down Mode menus to select “Switched” and “Toggle”:
These settings will allow you to send two different values of a particular MIDI CC number each time you press the pad.
There are a couple of MIDI CC numbers that have been assigned the task of controlling filter brightness (CC# 74) or
harmonic content (CC# 71). We’ll use CC# 74 for this example.
Click on the CC number field and select the Brightness controller number as shown:
To Next Page
Loading...
