Worlde Orca mini 25 - Pad Velocity

HANGZHOU BLUE WHALE MUSIC TECHNOLOGY CO.,LTD HANGZHOU WORLDE MUSIC ELECTRONIC CO., LTD
WEBSITE: WWW.WORLDE.COM.CN EMAIL:SALES@WORLDE.COM.CN TEL:86 571 88730848
- 9 -
5.6.2 Pad Velocity
The Pad Curve setting is used to set the response curve of all 16 pads. It is not possible to set the response curve of the pads
independently.
Your Orca mini 25 offers 3 different pad velocity curves and 1 one constant velocity as shown below. The 3
rd
one is the constant velocity
with the value 127.
Pad Velocity Curves
To change the pad velocity curve:
Press the MENU button repeatedly until the OLED dispays “Pad curve” to start the function of selecting pad velocity curve. When this
function is valid, the OLED displays the “Pad velocity” and the Number of current pad velocity curve. It can be adjusted by +/- button and
confirmed by Enter button. The initial value is 1, adjusting scale is 1～4. The operation steps is shown as below and the OLED displays the
following:
(1) Press the MENU button repeatedly until the OLED dispays “Pad Velocity”.
(2) Press “+” or “-” button to adjust the pad velocity curve, the OLED will display the current selected velocity curve.
(3) Press the “Enter” button to confirm and the OLED will display “Done”. Holding the “Enter” button for 2 seconds to exit the edit mode.
5.6.3 Pad Pressure Control
Using the pressure control, the pads give you a different type of performance option on your Orca mini 25. You can control parameters on
your software in a way that would not be possible on a standard dial or slider. The pressure pads can be used to make some very
interesting effects.
As we’ve seen above, each pad can be assigned an individual MIDI controller number. As you apply more and more pressure to the pad,
the value of the controller you are sending will increase, until the maximum value is reached. On release, the pad will return to the
minimum value.
5.6.4 OCTAVE+/ OCTAVE-
Press the MENU button repeatedly until the OLED dispays “Octave” to start the function of Octave. This function allows the keyboard to
change the Pitch up/down by octave. When this function is valid, the OLED displays the “Octave” and the value of current transposition. It
can be adjusted by +/- button. The initial value is 0, adjusting scale is -4～4. The operation steps is shown as below and the OLED
displays the following:
(1) Press the MENU button repeatedly until the OLED dispays “Octave”.
(2) Press “+” or “- ” button to adjust the keyboard octave, the OLED will display the current octave. Holding the “Enter” button for 2 seconds
to exit the edit mode.