Worlde Orca mini 25 - Store all parameters; Recall all parameters

HANGZHOU BLUE WHALE MUSIC TECHNOLOGY CO.,LTD HANGZHOU WORLDE MUSIC ELECTRONIC CO., LTD
WEBSITE: WWW.WORLDE.COM.CN EMAIL:SALES@WORLDE.COM.CN TEL:86 571 88730848
- 11 -
(5) Press the MENU button repeatedly until the OLED dispays “Pad color G”.
(6) Press “+” or “-” button until the OLED displays 0.
(7) Press the “Enter” button to confirm and the OLED will display “Done”.
(8) Press the MENU button repeatedly until the OLED dispays “Pad color B”.
(9) Press “+” or “-” button until the OLED displays 0.
(10) Press the “Enter” button to confirm and the OLED will display “Done”. Holding the “Enter” button for 2 seconds to exit the edit mode.
Reference RGB No. for some colors:
COLOR R. G. B
WHITE 127 127 127
BLACK 0 0 0
RED 127 0 0
GREEN 0 127 0
BLUE 0 0 127
CYAN 0 127 127
MAGENTA 127 0 127
YELLOW 127 127 0
ORANGE 127 82 0
5.7 Other controls
5.7.1 Store all parameters
Press the MENU button repeatedly until the OLED dispays “Store all parameters” to start the function of storing parameters. It stores 3
groups setup value. When this function is valid, the OLED displays the “Store all parameter” and the current strorage group number. It
can be adjusted by +/- button and confirmed by Enter button. The initial value is 1, adjusting scale is 1～3. The operation steps is shown
as below and the OLED displays the following:
(1) Press the MENU button repeatedly until the OLED dispays “Store all parameter”.
(2) Press “+” or “-” button to adjust the memory area and the OLED will display the current memory area.
(3) Press the “Enter” button to confirm and the OLED will display “Done”. Holding the “Enter” button for 2 seconds to exit the edit mode.
5.7.2 Recall all parameters
Press the MENU button repeatedly until the OLED dispays “Recall all parameter” to start the function of recalling all parameters. When this
function is valid, the OLED displays the “Recall all parameter” and the current strorage group number. It can be adjusted by +/- button and
confirmed by Enter button. The initial value is 1, adjusting scale is 1～3. The operation steps is shown as below and the OLED displays the
following:
(1) Press the MENU button repeatedly until the OLED dispays “Recall all parameter”.
(2) Press “+” or “-” button to select the memory area and the OLED will display the current memory area.
(3) Press the “Enter” button to confirm and the OLED will display “Done”. Holding the “Enter” button for 2 seconds to exit the edit mode.