11
18. Use outdoor extension leads
- When the tool is used outdoors, use only
extension cords intended for outdoor use
and so marked.
19. Stay alert
- Watch what you are doing, use common
sense and do not operate the tool when
you are tired.
20 - Check damaged parts
- Before further use of tool, it should be
carefully checked to determine that it will
operate properly and perform its intended
function.
- Check for alignment of moving parts,
binding of moving parts, breakage of parts,
mounting and any other conditions that
may affect its operation.
- A guard or other part that is damaged
should be properly repaired or replaced
by an authorized service centre unless
otherwise indicated in this instruction
manual.
- Have defective switches replaced by an
authorized service centre.
Do not use the tool if the switch does not
turn it on and off.
21. Warning
- The use of any accessory or attachment
other than one recommended in this
instruction manual may present a risk of
personal injury.
22. Have your tool repaired by a qualified
person
- This electric tool complies with the
relevant safety rules. Repairs should only
be carried out by qualified persons using
original spare parts, otherwise this may
result in considerable danger to the user.
23. If the replacement of the supply cord
is necessary, this has to be done by
the manufacturer or his agent in order
to avoid a safety hazard.
ADDITIONAL SAFETY
INSTRUCTIONS FOR BLADE
RUNNER
1. Safety precautions
1) Do not use saw blades which are damaged
or deformed;
2) Replace the table insert when worn;
3) Connect the machine to a dust-collecting
device when sawing wood and tile;
4) Do not operate the machine when the door
or guard protecting the saw blade is open;
5) Do not clean the saw blade whilst it is in
motion;
6) Wear suitable personal protective
equipment, when necessary, this could
include:
- Hearing protection to reduce the risk of
induced hearing loss;
- Respiratory protection to reduce the risk of
inhalation of harmful dust;
- Gloves for handling the saw blade and
rough material.
2. Safe operation
1) When straight cutting against the fence use
a push stick;
2) During transportation the saw blade guard
should be fully down and close to the
table;
3) When bevel-cutting with the table inclined,
place the guide on the lower part of the
table;
4) When cutting round timber use a suitable
holding device to prevent twisting of the
workpiece;
5) Lifting and transportation positions shall
clearly be indicated on the tool;
6) Do not use guarding for handling or
transportation;
7) Adjust the adjustable guard as close to the
workpiece as practicable;
8) Adjust the guard as close as possible to
the piece to be cut;
9) Make sure the workpiece is firmly contact
with the work table. Never lift it by your
hands;
10) Never adjust or assemble the rip fence or
mitre gauge when the machine is working.
To Next Page
Loading...
