Lawn Mowing Robot EN
9
3.2 How does my Landroid
®
L know
where to go?
Your Landroid
®
L is capable of doing things on its own. The Landroid
®
L
knows when it needs to go to its Charging Base (3) to charge, can sense
when it is raining, can stop itself if it senses a problem, and knows to stop,
drawback, and then turn around when it bumps into something blocking its
path or other object. The Landroid
®
L will also automatically stop its Blade
Turning Disc (16) from rotating if it is lifted off the ground to prevent an
accident.
A. Finding the Charging Base
When your
Landroid
®
L
needs to recharge, it will stop mowing and follow the
Boundary Wire (23) in an anti-clockwise direction back to its Charging Base.
Landroid
®
L
is pre-programmed to mow the grass near the boundary wire
once a week.
If you want to mow the grass near the boundary wire at other times, open
the keypad window, press the home button and close the keypad window.
Landroid
®
L
will stop mowing, locate the boundary wire and mow the grass
near the boundary wire while it locates the charging station. We suggest you
use this function when the battery power is more than 75%. You can check
the battery power in the display.
B. Rain sensors
The Landroid
®
L is fitted with a Rain Sensor (12) that will detect rain drops
and tell the Landroid
®
L to stop mowing and follow the Boundary Wire back
to its Charging Base. (See Fig. B)
The Landroid
®
L is programmable to have a delay start function (0 – 180
mins) when it rains. When the rain sensors are wet, the Landroid
®
L
returns to its docking station. Only when the rain sensors become dry
will the Landroid
®
L begin the delay start countdown or return to mowing
immediately. See the Programming and Troubleshooting Guide for more details.
C. Sensing the boundary wire
The Landroid
®
L always obeys the border set by the Boundary Wire and uses two sensors at its front to sense when it is
getting close (See Fig. C). Before changing direction, the Landroid
®
L will overrun the Boundary Wire up to 25cm*.
*This is the recommended distance. Use the provided distance gauge to ensure proper installation.
D. Starting and stopping while mowing
If you would like to command the Landroid
®
L to stop mowing, then simply press the STOP button (8) on top of the mower.
It will not begin mowing again until you have press
and closed its Keypad Window. (See Fig. D, E)
If the Landroid
®
L senses that something is wrong, it will display a fault message on the Display (20), and will turn itself off if
it does not receive any input from the user within 20 min (for information on fault messages refer to the Programming and
Troubleshooting Guide).
E
D
B
C
To Next Page
Loading...
Need help?
General
