Getting started
EN
17
Lay perimeter islands, if needed
• Protect flower beds, ponds, tree roots and other areas by surrounding them with the boundary wire
• Depart the edge at a right angle to reach the area to be protected
• Surround the area with the wire, keeping 26cm distance, until you close the island
• Always lay the wire clockwise. Failing to do so will make the mower drive into the island
• Return to the edge of the lawn following the same path
10
Bertelsen method: how to make perfect 90° angles with corners facing the lawn
If there are 90 degree corners that face the inside of your lawn, use the Bertelsen ruler to help Landroid make perfect turns (and remove
the risk that Landroid hits an obstacle on the border of the lawn whilst doing this manoeuvre).
26cm
26cm
26cm
11
Close the loop
Once you have completed laying the wire on the perimeter of your lawn, you will arrive back to the charging base.
• Pass the wire through the guide in the base, up to the clamp (fig.12)
• Cut the exceeding wire and strip the end with a pair of scissors
• Insert the stripped end into the black right clamp
IN
12
To Next Page
Loading...
Need help?
General
