Quick reference
EN
30
ERROR MESSAGES
Sometimes things can go wrong. Fortunately Landroid is smart enough to tell you if it is enountering an issue, so you can fix it. If in doubt,
please visit our website where you will find useful videos and further support.
MESSAGE CAUSE ACTION
Outside working area! Press START to
reset.
Landroid cannot find the boundary wire
signal.
1. If Landroid is actually outside of its
working area: turn power off, take
Landroid inside the working area, turn
the power on and press start.
2. If Landroid is inside its working area
check if the LED on the charging base is
solid green. If red, check if the boundary
wire is properly connected to the
charging base and that the base is
connected to a suitable power supply.
If they are properly connected, the
boundary wire terminals are clamped
incorrectly and must be reversed.
WRONG PIN! Please retry. PIN code is wrong. Input the correct PIN or re-set your PIN.
Blade motor fault! Press START to reset. Blade disc is blocked by an object, e.g.
a branch.
Turn power off.
Turn Landroid upside down and check
if there’s anything preventing the blade
disc from rotating and remove any
obstruction.
Turn Landroid upright.
Turn power on. Press start.
Blade is over-loaded by thick dense
grass.
Turn power off.
Take Landroid to an area with short
grass or adjust the cutting height to a
higher setting.
Turn power on. Press start.
Wheels motor fault! Press START to
reset.
Wheel motor is blocked in some way. Turn power off and take Landroid to an
area free from obstacles.
Turn power on. Press start.
If the error message is still displayed,
turn power off. Turn Landroid
upside-down and check if there’s
anything preventing the wheels from
rotating.
Remove any obstruction, turn Landroid
upright, turn power on.
To Next Page
Loading...
Need help?
General
