Quick reference
EN
32
Can’t find charge station press START
to reset.
Boundary wire is beyond its maximum
length (350m or machine doesn’t have
enough power to go back to charging
station.
Take Landroid to the charging station.
Mower locked! With the ‘Lock Function’ enabled, if your
Landroid does not receive a signal from
your Wi-Fi router for 3 days, then it gets
locked as a security measure.
This could be because your router lost
its power or because you changed your
Wi-Fi router or network provider.
Please reconnect Landroid to the Wi-Fi
networtk it has been originally paired
with.
If this is not possible, contact Cutomer
Service.
NOTES
• Before turning power on, always check Landroid is inside its working area. If not, the message “Outside working area! Press START to
reset” will be displayed. This message is also displayed when Landroid is partly but not completely inside its working area
• If for any reason—i.e. a party, children playing...—you want to park your Landroid in the charging base: press home then . Landroid
will go to its base and stay there. Please note Landroid will now wait until the next scheduled mowing session. If you want to re-start it
at anytime, press start then to start your Landroid
• If an error repeatedly occurs in the same area of your lawn, you might have a problem with the boundary wire so please refer to the
installation instructions and check your set up is correct with its help
• If your lawn is divided in two separated areas, connected by a corridor less than 1m wide, one of which is not provided with the
charging base: when Landroid runs out of charge, take it manually to the charging base
• If Landroid runs abnormally once in a while, please reset it by turning it off and removing the battery for 30 seconds, then restart it. If the
problem cannot be solved, please contact our Customer Service for help
To Next Page
Loading...
