Pole saw attachment EN
10
NOISE DATA
A weighted sound pressure L
pA
= 79.81dB(A)
K
pA
3dB(A)
A weighted sound power L
wA
= 99.81dB(A)
K
wA
3dB(A)
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN ISO 11680-1.
Vibration emission value: a
h
=2.418m/s
2
Uncertainty K = 1.5m/s²
The declared vibration total value may be used for comparing
one tool with another, and may also be used in a preliminary
assessment of exposure.
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool
is used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained
Using the correct accessory for the tool and ensuring it is
sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed
WARNING! To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
WA0222
Hex key 1
Extension pole 1
We recommend that you purchase your accessories listed
in the above list from the same store that sold you the tool.
Refer to the accessory packaging for further details. Store
personnel can assist you and offer advice.
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the
instruction book carefully.
INTEND USE
This attachment is intended for sawing of trees, tree
trunks, branches, wooden beams, planks, etc. Cuts
can be sawed with or across the grain. This product
is not suitable for sawing mineral materials.
Action Figure
ASSEMBLY
Connecting
Remove the existing attachment, and
connect the pole saw attachment. Slip
the attachment into the shaft of the
main unit and secure in place with the
locking knob.
Place the saw on a solid, level surface
before assembling. Before using,
make sure it is well connected.
W
ARNING! Do not install the
battery pack before it has
been completely assembled.
Always use gloves when handling
the chain.
See Fig. A
Removing the bar and chain sheath. See Fig. B
To Next Page
Loading...
Need help?
General
