9
2-in-1 Grass Trimmer/Edger WG118E
5. ATTACHING EXTENSION CORD(See Fig. G)
An extension cord retainer is built into the Rear Handle
(1) that prevents the cord from coming unplugged.
To use this feature, simply double the extension
cord about (203mm from the end, forming a small
loop. Insert this loop into the slot on the back of the
handle. Hook the end of the loop over the tab. Gently
tug on the cord to insure that it is firmly retained in
the trimmer’s handle. Plug the receptacle end of the
extension cord into the Plug Insert (2) in the trimmer.
6. ADJUSTMENT OF TRIMMER HEAD ANGLE
To adjust the trimmer head angle downwards, put
one foot on the motor housing, then grip the Rear and
Auxiliary handles, and apply adequate force to adjust,
as shown in Fig. H1.
To adjust the trimmer head angle upwards, put one
foot on the Safety Guard (4), then grip the Rear and
Auxiliary handles and apply adequate force to adjust,
as shown in Fig. H2.
7. USING THE ON/OFF TRIGGER
Press and hold the on/off trigger to start the trimmer.
Release to stop.
8.TRIMMING
Hold the bottom of the trimmer head just above the
ground and at a slight angle. Allow only the tip of line
to make contact with the grass. Let the trimmer line
work at its own pace; do not force the trimmer line into
the work area.
9. EDGING (See Fig. I)
First, rotate the Rear Handle (1) 90 degree clockwise (See
“Main Handle Rotation”, Fig. E1&E2).
Adjust the trimmer head angle to be the lowest horizontal
setting (See “Adjustment of the Trimmer Head Angle”, Fig
H1). Then position the Edger Wheel (8) on the ground for
edge mode (See Fig. I). There are two white lines, located
on each end of the Safety Guard (4), that show the cutting
plane of the trimmer line. Align these marks with the
edge of your lawn.
While edging, allow the tip of the line to make contact.
Do not force the line. The wheel helps to prevent the
unit from touching the ground. Take extra caution while
edging as objects can be thrown from the trimmer line.
10. AUTOMATIC LINE FEED SYSTEM
When initially switching on the trimmer, a small length
of line is fed out.
To Next Page
Loading...
