Worx WG163.9 - User Manual

Other manuals for Worx WG163.9

Manual28 pages

Important Safety Instructions32 pages

Instruction Manual32 pages

Questions and Answers:

B
brianjacksonSep 2, 2025
Why Worx Trimmer cutting time per battery charge is too short?
- E
  Eileen CarpenterSep 2, 2025
  If your Worx Trimmer isn't running as long as it should on a single charge, there are a few potential reasons. First, if the battery hasn't been used for a while or has only been charged briefly, try fully charging it before use. Also, very high grass can drain the battery quickly, so trim the grass to a shorter length. Finally, the battery itself might be defective and need replacement.
W
Whitney MontesAug 31, 2025
What to do if the battery charge indicator is continuously lighting on my Worx WG163.9 Trimmer?
- O
  orrveronicaAug 31, 2025
  If the battery charge indicator on your Worx Trimmer is continuously lit but charging isn't possible, it may be due to a few reasons. First, the battery might not be properly inserted, so try reinserting it. Second, the battery contacts could be contaminated, so clean them. Finally, the battery itself might be defective, requiring a replacement.
V
Vickie SmithAug 29, 2025
What to do if my Worx WG163.9 does not cut?
- C
  Christopher HarveyAug 29, 2025
  If your Worx Trimmer isn't cutting, start by checking the cutting line. If the line is broken, replace it. Also, ensure the battery is fully charged. Clear away any grass entangled around the cutting head.
E
Edward VelezAug 28, 2025
What to do if command feed does not work on Worx Trimmer?
- J
  jacqueline41Aug 28, 2025
  If the command feed isn't working on your Worx Trimmer, it may be because the cutting line isn't wound well; rewind it properly. Another reason could be that the line is tangled, so untangle it. Finally, the line might be used up, requiring you to replace the cutting line.
T
tiffany81Aug 26, 2025
Why is my Worx WG163.9 Trimmer not working?
- J
  Julie SantanaAug 26, 2025
  If your Worx Trimmer isn't working, there are several potential causes. First, the battery might be discharged, so try charging it. If the battery is either too hot or too cold, allow it to reach a suitable temperature. It's also possible that the motor is broken, in which case it should be serviced. Finally, damaged internal wiring could be the culprit, requiring inspection and repair.
M
mfryAug 25, 2025
How to fix command feed that does not work on Worx WG163.9?
- A
  Aaron RuizAug 25, 2025
  If the command feed on your Worx Trimmer isn't working, it could be due to a few reasons. The cutting line might not be wound well, so rewind it. The line could also be tangled, so untangle it. Finally, the line might be used up, so replace it.
J
Jennifer JonesAug 22, 2025
Why my Worx Trimmer fails to operate?
- A
  Anthony HenryAug 22, 2025
  If your Worx Trimmer fails to operate, there are a few potential causes. The battery might be discharged, so try charging it. Alternatively, the battery could be too hot or cold; allow it to return to room temperature. In more serious cases, the motor or internal wiring might be damaged, requiring you to contact an authorized service agent.