14
3
in
1
Grass Trimmer/Edger
WG169E WG169E.5
WG169E.9
eyelet of the Spool Holder. Place new Spool into the
holder with the cut out areas of the Spool facing
inward or down. When installed into the Spool
Holder, the smooth side of the Spool should be
visible.
Release line from cleat on the Spool.
Refit the Spool Cap Cover.
TO MANUALLY WIND LINE (See Fig. L1-L4)
Take approximately 3m of line. Insert 15mm of line into
the Spool holes and wind line in the direction of the
arrows on the top of the Spool.
Leave approximately 100mm of line unwound and
place into the cleat.
Ensure that the line is neatly coiled on the Spool.
Failure to do so will impair the efficiency of the
automatic line feed.
Then fit the Spool as described above in “Replace the
trimmer line and Spool”.
MAINTENANcE
After use, disconnect the battery from the mains
and check for damage.
Your power tool requires no additional lubrication
or maintenance. There are no user serviceable parts
in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with a
dry cloth. Always store your power tool in a dry room
temperature location. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
To Next Page
Loading...
