What to do if Worx Lawn and Garden Equipment charger is not plugged in?
If the plug of the battery charger for your Worx Lawn and Garden Equipment is not plugged in properly, insert the mains plug fully into the socket outlet.
What to do if Worx WG169E.5 Trimmer fails to operate?
If the trimmer isn't working, first, check if the battery is discharged and charge it if necessary. If the battery is either too hot or too cold, allow it to reach room temperature. Also, the motor could be broken, requiring replacement, or the internal wiring of the machine might be damaged, which would need repair.
How to fix Worx Trimmer when the cutting line is tangled or not winding well?
If the cutting line on your Worx Trimmer is not wound well, manually feed the line; if it still won't feed out, remove the spool and rewind the line. If the line is used up, replace it with a new spool of line.
What to do if my Worx WG169E.5 battery is discharged or the motor is broken?
If your Worx Trimmer's battery is discharged, recharge it, referring to the section on 'HOW TO CHARGE YOUR BATTERY'. If the battery is too hot or cold, allow it to cool or warm to room temperature. If the motor is broken or the internal wiring is damaged, contact a service agent for assistance.
What to do if the line is broken or grass is entangled in my Worx WG169E.5 Trimmer?
If the line of your Worx Trimmer is broken, replace it. If the battery isn't fully charged, recharge it, consulting the 'HOW TO CHARGE YOUR BATTERY' section. If the motor is broken or the speed is too low, contact a service agent. If grass is entangled around the cutting head, remove it.
What to do if Worx Lawn and Garden Equipment battery is too hot?
If the battery of your Worx Lawn and Garden Equipment is too hot or too cold, allow it to cool or warm.
How to maintain Worx Lawn and Garden Equipment battery after long storage?
If the battery of your Worx Lawn and Garden Equipment has not been used for a long period or has only been charged for a short time, fully charge it. You can also check the section on how to charge your battery.
What to do if Worx Lawn and Garden Equipment cutting line is not wound well?
If the cutting line of your Worx Lawn and Garden Equipment is not wound well, manually feed the line. If it still cannot feed out, remove the spool and rewind the line.
Why Worx WG169E.5 Trimmer cutting time per battery charge is too short?
The cutting time might be too short if the battery hasn't been used for a long period or has only been charged for a short time, so ensure regular use and proper charging. Also, this can happen if the grass is too high; in this case, cut the grass to a manageable height. A defective battery can also cause this, so consider replacing the battery.
What to do if my Worx WG169E.5 Trimmer battery charger is not working?
If the plug of the Worx Trimmer battery charger is not plugged in properly, fully insert it into the socket outlet. If the socket outlet, mains cable, or battery charger is defective, check the mains voltage and have the battery charger checked by an authorized after-sales service agent.
General| Power Source | Battery |
|---|---|
| Voltage | 20V |
| Battery Capacity | 2.0 Ah |
| Cutting Width | 30 cm |
| Edging Function | Yes |
| Telescopic Shaft | Yes |
| Line Diameter | 1.65 mm |
To Next Page
