TO MANUALLY WIND LINE
(See Fig. L1-L4)
Take approximately 10ft (3m) of line. Insert 5/8”(15mm)
of line into the Spool holes and wind line in the
direction of the arrows on the top of the Spool.
Leave approximately 4” (100mm) of line unwound and
place into the cleat.
Ensure that the line is neatly coiled on the Spool.
Failure to do so will impair the efficiency of the
automatic line feed.
Then fit the Spool as described above in “Rep lace
the trimmer line and Spool”
MAINTENANCE
After use, disconnect the battery from the tool and
check for damage.
Your power tool requires no additional lubrication
or maintenance. There are no user serviceable parts
in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with a
dry cloth. Always store your power tool in a dry room
temperature location. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
To Next Page
Loading...
Need help?
General
