Why Worx WG169E.5 Trimmer cutting time per battery charge is too short?
The cutting time might be too short if the battery hasn't been used for a long period or has only been charged for a short time, so ensure regular use and proper charging. Also, this can happen if the grass is too high; in this case, cut the grass to a manageable height. A defective battery can also cause this, so consider replacing the battery.
Why is my Worx Trimmer not working after long storage or with high grass?
If the Worx Trimmer battery hasn't been used for a long time or was only charged briefly, fully charge it, referring to the 'HOW TO CHARGE YOUR BATTERY' section. If the grass is too high, cut it in stages. If the battery is defective, replace it.
What to do if my Worx WG169E.5 Trimmer battery charger is not working?
If the plug of the Worx Trimmer battery charger is not plugged in properly, fully insert it into the socket outlet. If the socket outlet, mains cable, or battery charger is defective, check the mains voltage and have the battery charger checked by an authorized after-sales service agent.
What to do if Worx Lawn and Garden Equipment line is used up?
If the line of your Worx Lawn and Garden Equipment is used up, replace it with a new spool of line.
What to do if Worx WG169E.5 auto feed does not work?
If the auto feed on your Worx Trimmer isn't working, it could be due to the cutting line not being wound well; rewind it properly. The line might also be tangled, so untangle it. If the line is used up, replace it.
Why does Worx WG169E.5 run intermittently?
An intermittent Worx Trimmer could be caused by a broken motor, so consider replacing it. Also, check if the battery is not fully charged and charge it completely. A defective On/Off switch can also cause this issue, so replace the switch if necessary.
What to do if Worx WG169E.5 machine does not cut?
If your Worx Trimmer isn't cutting, the line may be broken, so replace the cutting line. Another reason could be that the battery is not fully charged, so charge the battery. If the motor is broken (resulting in low speed), replace it. Also, check for and clear any grass entangled around the cutting head.
What to do if the line is broken or grass is entangled in my Worx WG169E.5 Trimmer?
If the line of your Worx Trimmer is broken, replace it. If the battery isn't fully charged, recharge it, consulting the 'HOW TO CHARGE YOUR BATTERY' section. If the motor is broken or the speed is too low, contact a service agent. If grass is entangled around the cutting head, remove it.
What to do if my Worx WG169E.5 battery is discharged or the motor is broken?
If your Worx Trimmer's battery is discharged, recharge it, referring to the section on 'HOW TO CHARGE YOUR BATTERY'. If the battery is too hot or cold, allow it to cool or warm to room temperature. If the motor is broken or the internal wiring is damaged, contact a service agent for assistance.
How to fix Worx Trimmer when the cutting line is tangled or not winding well?
If the cutting line on your Worx Trimmer is not wound well, manually feed the line; if it still won't feed out, remove the spool and rewind the line. If the line is used up, replace it with a new spool of line.
General| Power Source | Battery |
|---|---|
| Voltage | 20V |
| Battery Capacity | 2.0 Ah |
| Cutting Width | 30 cm |
| Edging Function | Yes |
| Telescopic Shaft | Yes |
| Line Diameter | 1.65 mm |
To Next Page
