3
Electric Lawn Mower WG705E
n) Do not put hands or feet near or under
rotating parts. Keep clear of the discharge
opening at all times.
o) Do not transport the lawnmower while the
power source is running. Never pick up or
carry the lawnmower while the motor is
running.
p) Stop the machine and disconnect the plug
from the mains. Make sure that all moving
parts have come to complete stop.
- Whenever you leave the machine;
- Before clearing blockages or unclogging
chute;
- Before checking, cleaning or working on the
lawnmower;
- After striking a foreign object. Inspect
the lawnmower for damage and make
repairs before restarting and operating the
lawnmower.
If the lawnmower starts to vibrate
abnormally (check immediately)
- Inspect for damage;
- Replace or repair any damaged parts;
- Check for and tighten any loose parts.
MAINTENANCE AND STORAGE
a) Keep all nuts, bolts and screws tight to
be sure the machine is in safe working
condition;
b) Check the grass catcher frequently for wear
or deterioration;
c) On machines with multi blade, take care as
rotating one blade can cause other blades
to rotate.
d) Be careful during adjustment of the
machine to prevent entrapment of the
fingers between moving blades and fixed
parts of the machine.
e) Always allow the machine to cool down
before storing.
f) When servicing the blades be aware that,
even though the power source is switched
off, the blades can still be moved.
g) Replace worn or damaged parts for safety.
Use only genuine replacement parts and
accessories.
RECOMMENDATION
To connect the machine only to a supply
circuit protected by a residual current
device (RCD ) with a tripping current of not
more than 30 mA.
Read instruction handbook before
operation this machine.
Keep bystanders away
Beware of sharp blades. Blades
continue to rotate after the motor
is switched off- Remove plug from
mains before maintenance or if
cord is damaged.
Keep the supply flexible cord away
form the blades.
Double Insulation
RCM approval mark
SYMBOLS
To Next Page
Loading...
Need help?
General
