Quick reference
EN
34
ERROR MESSAGES
Sometimes things can go wrong. Fortunately Landroid Vision is smart enough to tell you if it is enountering an issue, so you can
fix it. If in doubt, please visit our website where you will find useful videos and further support.
MESSAGE CAUSE ACTION
Battery pack cover is open. Close the battery pack cover.
Outside working
area! Press START to
reset.
Landroid Vision cannot find
the lawn border.
1. If Landroid Vision is actually outside of its working area: turn power
off, take Landroid Vision inside the working area, turn the power on
and press start.
2. If Landroid Vision is inside its working area check if the LED on the
charging pile is solid green.
WRONG PIN! Please
retry.
PIN code is wrong. Input the correct PIN or re-set your PIN.
Blade motor fault!
Press START to
reset.
Blade disc is blocked by an
object, e.g. a branch.
Turn power off.
Turn Landroid Vision upside down and check if there’s anything pre-
venting the blade disc from rotating and remove any obstruction.
Turn Landroid Vision upright.
Turn power on. Press start.
Blade is over-loaded by thick
dense grass.
Turn power off.
Take Landroid Vision to an area with short grass or adjust the cutting
height to a higher setting.
Turn power on. Press start.
Wheels motor fault!
Press START to
reset.
Wheel motor is blocked in
some way.
Turn power off and take Landroid Vision to an area free from obsta-
cles.
Turn power on. Press start.
If the error message is still displayed, turn power off. Turn Landroid Vi-
sion upside-down and check if there’s anything preventing the wheels
from rotating.
Remove any obstruction, turn Landroid Vision upright, turn power on.
Upside down! Press
START to reset.
This could have happened
when Landroid Vision came
into contact with a sloping
surface which made it over-
turn.
Turn Landroid Vision upright and remove any obstacle that might
have caused Landroid Vision to overturn.
Mower trapped!
Press START to
reset.
Landroid Vision is trapped.
Turn power off.
Take Landroid Vision to an area of your lawn free of obstacles, then
turn power on. Press start.
If the error message is still displayed: turn power off, turn Landroid
Vision upside-down. Check if there is anything preventing the wheels
from rotating.
Remove any obstruction, turn the Landroid Vision upright, turn power
on.
Mower lifted! Press
START to reset.
Landroid Vision has been
lifted up.
Turn power off.
Take Landroid Vision to an area clear of obstacles, turn power on.
Press start.
If the error message is still displayed: turn power off, turn Landroid
Vision upside-down and check there’s anything that can cause Lan-
droid Vision to be lifted up.
Remove any possible object, turn Landroid Vision upright, turn power
on.
To Next Page
Loading...
