Quick reference
EN
37
SYMPTOM CAUSE SOLUTION
Landroid Vision is starting
to have shorter run-times
between charges.
Something is clogging in the blade
disc creating friction and increasing
power consumption.
Take off the blade disc and clean it. Maybe the grass is
too high and too thick.
Landroid Vision is shaking heavily be-
cause the blade disc is unbalanced.
Check the blade disc and blades, remove debris and
foreign objects from the blades and blade disc.
Replace the blades with a new set.
The battery may be exhausted or old. Replace battery.
The working time is up. Reset the working time.
Landroid Vision is not
operating at the correct
time.
The clock is not set to the correct
time.
Set the clock to the correct time.
Programmed cutting times for Lan-
droid Vision are not correct.
Change the time settings for the mower to start and stop.
The percentage of weekly operating
time set through App has changed.
Set the correct percentage through App.
Landroid Vision can not
find the charging base.
The direction of the charging base is
incorrect.
Make sure Landroid Vision dock right towards the char-
ging base and departures in anti-clockwise direction.
There are obsacles in front of the
charging base.
Please remove the obstacles within the 2 m in front of the
charging base.
The QR code is sheltered.
Make sure the QR code is clear and that there is nothing
directly on it or above it.
Landroid Vision cannot
correctly dock with the
charging pile.
Environmental influences. Restart Landroid Vision.
Poor connection caused by debris on
the charging strip.
Clean the contact pins located on the charging pile and
the charging strip on Landroid Vision using a cloth.
The green light on the
charging pile turns
on before charging is
complete.
The charging base is overheating or
overcooling.
Place the charging base in a shady area or wait until it
reaches the normal temperature.
Landroid Vision wheels
skid or repeatedly slip.
Obstacles, such as twigs and bran-
ches may be lodged under Landroid
Vision.
Remove objects from underside of Landroid Vision.
The lawn is too wet.
Exclude the wet or soft ground areas by using the ma-
gnetic strip or by creating a non-grass pathway that is
more than 5 cm wide until the lawn is dry again.
Landroid Vision slips out
of its working area.
Low grip of Landroid Vision drive
wheels.
Please check the wheels are clean and free of mud in
order to have the maximum grip possible.
The slope is steeper than 30 % (17
o
).
Exclude the sloped area by using the magnetic strip or
by creating a non-grass pathway that is more than 5 cm
wide directly beside the slope.
Recognition error.
Remove the obstacle if there is one. Using the magnetic
strip or by creating a non-grass pathway that is more
than 5 cm wide on the lawn edge ensure that the mower
functions correctly.
There is grass whose height is higher
than 15 cm.
Trim the grass to below 15 cm. Lay magnetic strips or set
up a 5 cm non-grass pathway if there are steps, cliffs or a
pond below the grass.
To Next Page
Loading...
