What to do if Worx Lawn Mower crashes on standby?
If your Worx Lawn Mower's operating system crashes while charging or on standby, try restarting the mower, as it could be due to a software or display fault.
What to do if my Worx WR213E Lawn Mower does not charge?
If your Worx Lawn Mower isn't charging, check that the power cord is properly connected to the charger and the charger is connected to a working power supply. Also, ensure that both charging strips on the mower touch the center of the charging contacts on the charging pile.
Why does my Worx WR213E have shorter run-times?
Shorter run times for your Worx Lawn Mower can be caused by several factors. Check the blade disc for clogs and clean it, especially if the grass is high or thick. Examine the blade disc and blades for debris and replace them if necessary, as an unbalanced disc can increase power consumption. The battery might also be old and need replacement, or the working time may need to be reset.
Why Worx WR213E Lawn Mower cannot correctly dock with the charging pile?
If your Worx Lawn Mower isn't docking correctly, try restarting it, as environmental factors may be interfering. Also, clean the contact pins on the charging pile and the charging strip on the mower with a cloth to ensure good connection.
What to do if Worx WR213E software upgrade fails?
If the software upgrade fails on your Worx Lawn Mower, move closer to the router to strengthen the Wi-Fi signal. Also, ensure that the battery level is above 50% by placing the mower on the charging station.
How to fix the LED light on the Worx WR213E charging pile when it doesn't turn on?
If the LED light on your Worx Lawn Mower's charging pile isn't turning on, the cause may be a lack of power. Ensure the charging base is correctly connected to the charger, and that the charger is properly connected to a functioning power supply.
Why Worx WR213E turns on, but the blade disc does not spin?
If your Worx Lawn Mower turns on but the blade disc doesn't spin, it's normal when the mower is searching for the charging base to recharge automatically.
Why does the green light turn on early on my Worx WR213E Lawn Mower charging pile?
If the green light on the charging pile of your Worx Lawn Mower turns on before charging is complete, the charging base may be overheating or overcooling. Place the charging base in a shady area or wait until it reaches a normal temperature.
Why Worx WR213E secondary area is not mowed?
If the secondary area isn't being mowed by your Worx Lawn Mower, ensure the RFIDs are installed and reprogrammed correctly. Remove any obstacles between the RFIDs in the pathway. Also, make sure there is no boundary curved within 1.5 m range of the boundary wire for the RFID.
How to set the correct time on Worx WR213E Lawn Mower?
If your Worx Lawn Mower isn't operating at the correct time, ensure the clock is set correctly. Also, check and correct the programmed cutting times. If using the app, verify that the percentage of weekly operating time is set correctly.
General| Brand | Worx |
|---|---|
| Model | WR213E |
| Category | Lawn Mower |
| Language | English |
To Next Page
