Worx WX445 Original Instruction

Circular saw with laser EN
14
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.
PLUG REPLACEMENT
(UK & IRELAND ONLY)
If you need to replace the fitted plug then follow
the instructions below.
IMPORTANT
The wires in the mains lead are colored in
accordance with the following code:
BLUE =NEUTRAL BROWN =LIVE
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored
markings identifying the terminals in your plug,
proceed as follows. The wire which is colored
blue must be connected to the terminal which is
marked with N. The wire which is colored brown
must be connected to the terminal which is
marked with L.
WARNING!Never connect live or neutral
wires to the earth terminal of the plug. Only
fit an approved 13ABS1363/A plug and the correct
rated fuse.
NOTE: If a moulded plug is fitted and has to
be removed take great care in disposing of the
plug and severed cable, it must be destroyed to
prevent engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
Cable grip
Brown L (live)
13 Amp fuse approved
to BS1362

Worx WX445 Specifications

General

Blade diameter	190 mm
Number of teeth	24
Idle speed (max)	5000 RPM
Cutting depth (45º)	47 mm
Cutting depth (90º)	66 mm
Saw blade included	Yes
Quantity	1
Diamond disc	-
Product color	Multicolor
Input power	1600 W
Power source	AC

Weight and Dimensions

Depth	240 mm
Width	320 mm
Height	230 mm
Weight	4300 g