82
Use the big hex wrench to
adjust the two positioning
round head screws for
mounting the Z axis and the
three round head screws on
the bottom of the printer.
＊
Notice:
After adjusting the installation
,
the
screws should be properly tightened.
Screw
Big hex wrench
Round head screw
Big hex wrench
Round head screw
Washer
Adjustment of Z axis
83
Keep the two copper nut
mounting holes at the top of
the cantilever on the same
horizontal line as the center of
the screw.
Copper nut mounting hole
Screw
＊
Notice:
Move the cantilever to the top and adjust.
Adjustment of Z axis
To Next Page
Loading...