80
At this time
,
the cantilever will
fall along the guide rail and then
rotate counterclockwise by hand
to screw out the copper nut from
above.
＊
Notice:
Pay attention to the balls in the slider
when moving the slider to prevent it from
falling.
Copper nut
Cantilever
Adjustment of Z axis
81
Move the cantilever along the
guide rail to the top
,
and the
cantilever is parallel to the
working panel.
＊
Notice:
When moving the slider
,
please be careful
not to pull the cantilever out of the guide rail
to prevent the balls in the slider from falling
out.
Slide
Cantilever
Adjustment of Z axis
To Next Page
Loading...