+ = FULL RESET
A full reset will return Robosapien™V2 to his default body
position. This will not affect his programmed settings.
= QUICK RESET / WALKING GAIT CHANGE
This button returns Robosapien™V2 to his default standing
position. This will also change Robosapien™V2’s gait when walking
(See: Walking p.14)
+ = SLEEP / WAKE UP
Press once to make Robosapien™V2 enter sleep mode. Before his
final voice, you can stop him from going to sleep by pressing .
When in sleep mode Robosapien™V2 will not respond to his sensors
or any controller commands except Wake Up.
By pressing and holding + for about 2 seconds,
Robosapien™V2 will wake up. His programs are not affected.
+ + + = POWER DOWN
This turns Robosapien™V2 off completely. To turn him back on,
press the power button on his back OFF then ON again. His
programs are not affected.
= SONIC SENSORS ON /OFF
Press once to disable Robosapien™V2’s hearing.
Press again to enable Robosapien™V2’s hearing.
For more information on his Sonic Sensors See: Sonic
Sensors (P.26-27)
= VISION SYSTEMS ON /OFF
Press once to disable Robosapien™V2’s vision.
Press again to enable Robosapien™V2’s vision.
For more information on his Sonic Sensors See: Vision
Systems (P.22)
To Next Page
Loading...
