Free Roam
20
FREE ROAM
= FREE ROAM
You can put Robosapien™V2 into Free Roam mode so he can explore
his environment autonomously.
CAUTION: Do not put Robosapien™V2 near a table edge since he
could fall off when he starts up.
While Robosapien™V2 is in Free Roam mode he will avoid obstacles
using his infrared vision sensors (p.21), foot sensors (p.29) and
gauntlet sensors (p.29).
Note: If his vision or sonic sensors is OFF when he goes into Free
Roam mode, he will turn them ON but when he leaves Free Roam,
he will turn them OFF again. See: VISION SYSTEMS (p.21-22) and
Sonic Sensors (p.26-27) for further information.
Pressing any of the control buttons, making him flinch (see page
22) while he is walking, or touching one of his back foot sensors
(unless triggered while stationary) will make him exit Free Roam.
Robosapien™V2 will power down from Free Roam after
approximately ten minutes. To turn him back on, simply press the
power button, located on his back, off and then on again.
STANDING MODE
When left alone for more than 2.5 minutes with nothing in his
infrared vision range, Robosapien™V2 will perform random
animations roughly every 45 seconds (Standing Mode). During this
time if he hears a sound he will respond to it, but only vocally,
to prevent Robosapien™V2 from walking off tables in noisy rooms.
Robosapien™V2 will go to Sleep Mode after about 10 minutes if not
disturbed, but anything seen in his field of vision will delay this
time out.
To Next Page
Loading...
