Wren V5AP User Manual
18
Your Wren V5AP has been designed to accommodate firmware upgrades that enable you to
keep your product up to date in the event that Apple changes or adds features to AirPlay, or
Wren Sound Systems adds features or upgrades to the V5AP’s capability.
1. Download the latest firmware from our website at http://wrensound.com/software/
v5ap12/wren_V5.fw and save to your USB storage device (a.k.a. “thumb drive”).
2. Ensure “wren_v5.fw” is the only file on the USB drive, and that it is located in the
drive’s root directory (not in any folder).
3. With the power disconnected from the Wren V5AP, insert the USB drive into USB port
located on the rear panel of the Wren V5AP.
4. Connect the power to the Wren V5AP.
5. The Power indicator will blink for about 5 seconds, then turn off. The Volume indicator
will be white. The system is now in Standby Power mode.
6. Press and hold the “Source” and “Volume Up” buttons on the Wren V5AP Control Panel
at the same time. Then release the “Source” and “Volume Up” buttons. The system
enters its upgrade procedure when the Volume indicator changes to amber color. This
may take up to 10 seconds.
7. The Volume indicator will be amber and will blink slowly, indicating that the update
has started. This will change to a quickly blinking indicator after approximately 20
seconds, and will continue to blink quickly for approximately one minute until the
update is finished. At that time, the Volume indicator will change to solid amber.
8. Disconnect the power and remove the USB drive. Then reconnect the power.
9. The Power indicator will blink for about 5 seconds then turn off. The Volume indicator
will be white. The system is now in Standby Power mode.
10. Press the Power button. The WiFi indicator should be white. If it is amber, you must
reconnect the Wren V5AP to your network as described in the WiFi Network Setup for
AirPlay section above.
Firmware Upgrades
To Next Page
Loading...
