WRIGHT Z EXTREME - 9 Emissions Control Warranty; Emissions Warranty Terms and Responsibilities

9-1
9 FEDERAL EVAPORATIVE EMISSIONS CONTROL WARRANTY STATEMENT
YOUR WARRANTY RIGHTS AND OBLIGATIONS
The United States Environmental Protection Agency and Wright Manufacturing, Inc. are pleased to explain
the evaporative emissions control system warranty on your 2023 – 2024 commercial equipment. In the United
States new equipment that use small o󰀨-road engines must be designed, built, and equipped to meet the
stringent anti-smog standards. Wright Manufacturing, Inc. must warrant the emissions control system on
your commercial equipment for the periods of time listed below provided there has been no abuse, neglect or
improper maintenance of your small o󰀨-road engine or equipment leading to the failure of the emissions control
system.
Your emissions control system may include parts such as the carburetor or fuel-injection system, the ignition
system, catalytic converter, fuel tanks, fuel lines (for liquid fuel and fuel vapors), fuel caps, valves, canisters,
lters, clamps and other associated components. Also included may be hoses, belts, connectors, and other
emission-related assemblies.
Where a warrantable condition exists, Wright Manufacturing, Inc. will repair your commercial equipment at no
cost to you including diagnosis, parts and labor.
MANUFACTURER’S WARRANTY COVERAGE:
The evaporative emissions control system on your commercial equipment is warranted for two years. If any
emissions-related part on your commercial equipment is defective, the part will be repaired or replaced by
Wright Manufacturing, Inc.
OWNER’S WARRANTY RESPONSIBILITIES:
• As the commercial equipment owner, you are responsible for the performance of the required
maintenance listed in your owner’s manual. Wright Manufacturing, Inc. recommends that you retain all
receipts covering maintenance on your commercial equipment, but Wright Manufacturing, Inc. cannot
deny warranty coverage solely for the lack of receipts or for your failure to ensure the performance of all
scheduled maintenance.
• As the commercial equipment owner, you should however be aware that Wright Manufacturing, Inc. may
deny you warranty coverage if your commercial equipment or a part has failed due to abuse, neglect, or
improper maintenance or unapproved modications.
• You are responsible for presenting your commercial equipment to a Wright Manufacturing, Inc.
distribution center or service center as soon as the problem exists. The warranty repairs shall be
completed in a reasonable amount of time, not to exceed 30 days.
If you have any questions regarding your warranty rights and responsibilities, you should contact Wright
Manufacturing, Inc. at (301) 360-9810.
WARRANTED PARTS:
The following emission warranty parts listed below are covered:
(1) Fuel Tank
(2) Fuel Cap
(3) Fuel Lines (for liquid fuel and fuel vapors)
(4) Fuel Line Fittings
(5) Clamps
(6) Pressure Relief Valves
(7) Control Valves
(8) Control Solenoids
(9) Electronic Controls
(10) Vacuum Control Diaphragms
(11) Control Cables
(12) Control Linkages
(13) Purge Valves
(14) Gaskets
(15) Liquid/Vapor Separator
(16) Carbon Canister
(17) Canister Mounting Brackets
(18) Carburetor Purge Port Connector