www.wto-tools.comB80000-0 ENG10
3 Operation
3.1 Installation and operation advices
Avoid damage and dirt at the contact surfaces of the DTH and turret.
Rotate DTH spindle by hand before mounting on turret. In case of problems like roughness,
backlash or visual runout, do not use the DTH and contact WTO immediately for repair.
NOTICE
Never operate DTH beyond the maximum design torque and/or output RPM which are stated
on the DTH dimensional drawing.
Overloading the DTH will cause high wear and
possibly gear
breakage, and warranty will not cover damages caused by overloading.
WARNING
Remove or at least cover the cutting tool when
handling, transporting or storing the DTH.
Otherwise the danger of injury increases.
WARNING
Consider the operating instructions of the machine tool manufacturer.
To Next Page
Loading...
