www.wto-tools.com 3
Content
1 Safety 4
1.1 General 4
1.2 Purpose 5
1.3 Limits of use 5
1.4 Areas of responsibility 6
1.5 Hazard of use 7
1.6 Unpacking 8
2 Product Description 9
3 Operation 10
3.1 Installation and operation advices 10
3.2 Break in period 11
3.3 Changing the cutting tool 12
3.4 Changing the QuickFlex
®
adapter 13
3.5 DTH with internal coolant supply 14
3.6 Plug DTH coolant nozzle to use for IC only 14
3.7 Ball nozzle options 15
3.8 Copper pipe fitting options 15
3.9 Collet solutions for DTH’s with internal coolant supply 16
3.10 Adjusting the projection length of the cutting tool 16
3.11 One-hand wrench 16
3.12 Available ER collet nuts for QuickFlex
®
17
3.13 Turret centerreline alignment 18
3.14 Duty cycle ratio 19
3.15 Service interval 19
4 Care and Cleaning 20
5 Storage and Transport 21
5.1 Storage 21
5.2 Shipment 21
5.3 Shipping claims 21
6 Warranty 22
7 Disposal 22
8 DTH tolerances 23
To Next Page
Loading...
