www.wto-tools.comB80000-0 ENG2
Introduction
© 2019 WTO Werkzeugeinrichtungen GmbH. All rights reserved. This document may not be
copied or reproduced in whole or in part, or transferred to any other media or language, by
any means, without the prior written permission of WTO Werkzeugeinrichtungen GmbH.
General
WTO Driven Precision Toolholders (DTH) are high quality products with low maintenance
requirements. Please follow these instructions to maintain a high accuracy and a long
service life.
This manual contains important safety directions and instructions for product setup and
operation.
Keep for further reference
Product identification
Product type and article numbers are printed on the product.
Refer to this when contacting WTO.
Validity of this manual
This manual applies to the Driven Toolholders with QuickFlex
®
, Chapter 2 describes the nam-
ing rules.
Driven Toolholders with QuickFlex
®
Operating Instruction
can be downloaded in several languages:
To Next Page
Loading...
