www.wto-tools.comB80000-0 ENG20
NOTICE
DTH must be cleaned frequently in order to maintain the high quality and accuracy.
Chips, grease, oil, coolant, etc. must be removed after every 24 hours of operation.
Cleaning must be performed only by using a clean rag.
NOTICE
Never use compressed air to clean the DTH.
Compressed air forces chips and coolant through the sealing system causing premature
failure of the DTH.
Clean and check the DTH once per week, rotate spindle several times by hand.
Clean carefully the spindle area when removing the cutting tool.
4 Care and Cleaning
To Next Page
Loading...