wtw Multi 340i - Instrument Commissioning; Initial Setup Procedures

Multi 340i Commissioning
13
3 Commissioning
3.1 Scope of delivery
l Multi 340i handheld meter
l Plug-in power supply unit
l Operating manual and short operating manual
l 4 batteries, 1.5 V Mignon type AA (in the instrument)
For details of scope of delivery of SETs, see section 1.2 SET
S OF
EQUIPMENT and WTW catalog.
3.2 Initial commissioning
Perform the following activities:
l Set the date and time
l Connect the plug-in power supply (optional)
Setting the date and
time
1 Press the <M> key and hold it down.
2 Press the <ON/OFF> key.
The display test appears briefly on the display.
3 Press the <RUN/ENTER> key repeatedly until the date ap-
pears on the display.
4 Set the date of the current day with <▲> <▼>.
5 Confirm with <RUN/ENTER>.
The date (month) flashes in the display.
6 Set the current month with <▲> <▼>.
7 Confirm with <RUN/ENTER>.
The year appears on the display.
8 Set the current year with <▲> <▼>.
9 Confirm with <RUN/ENTER>.
The hours flash on the display.
10 Set the current time with <▲> <▼>.
11 Confirm with <RUN/ENTER>.
The minutes flash on the display.
12 Set the current time with <▲> <▼>.