X-Rite i1Pro User Manual

EN
11
Before you can use your device or see its status, you need to install the software
application on your computer. Please do not plug in the device‘s USB cable to your
computer until after you have installed the software from the DVD.
1. Install the software application from the DVD onto your PC or Macintosh
®
computer.
2. Review all instructions in this Quick Start Guide before you start using your new
device. For more detailed information, please refer to Contents on the software DVD.
3. Remove the “Install software and read manual before first use” warning sticker and
the positioning sensor protection sticker from the device.
4. After you have completed the software installation process, attach your i1Pro device
to your computer‘s USB port. If connected successfully both status indicators
light up solid white.
The X-Rite i1Pro will not work if it is connected to the USB port on your
keyboard or to a USB hub without external power supply.
i1Pro power rating: 5 V 500 mA.

X-Rite i1Pro Specifications

General

Measurement Technology	Spectrophotometer
Spectral Resolution	10 nm
Interface	USB
Measurement Aperture	4.5 mm
Measurement Time	Approx. 2 seconds