Need help?Do you have a question about the X10 WM100 and is the answer not in the manual?
General| Input Voltage | 120VAC, 60Hz |
|---|---|
| Technology | X10 |
| Maximum Load | 500W Incandescent |
| Compatible Devices | X10 |
| Power Source | Hardwired |
Guide for the first-time setup of the X10 WiFi HUB on a phone or tablet.
Steps to add additional phones and tablets to an existing HUB installation.
Steps to add and configure new X10 devices within the application.
Editing device properties like name, type, and dimmability.
Configuring timed ON/OFF or DIM commands for devices.
Manually turning devices ON/OFF or adjusting dim levels.
Organizing devices into rooms for easier control and management.
Steps to create new rooms and assign devices to them.
Using 'ROOM ON/OFF' commands for all devices in a specific room.
Renaming rooms or removing devices from rooms.
Creating complex commands for multiple devices with one touch.
Steps to create a new scene, name it, and add devices.
Setting ON/OFF states, dim levels, and delays for scene actions.
How to execute a created scene and monitor its status.
Adjusting HUB time and checking for firmware updates.
Manually checking and applying available firmware updates.
Viewing communication history, IP address, and clearing history.
Synchronizing application data with the WM100 HUB.
Reconfiguring the WiFi network or password for the HUB.
Resetting the WM100 HUB or the app to default factory settings.
To Next Page
