Xantrex Trace C Series - Configuration and Settings

©2000 Xantrex Technology Inc.
Configuring the C-Series
Three sets of jumpers are located on the right side of the controllers
circuit board. These jumpers control equalization, low voltage reconnect,
battery voltage, and operating modes. They must be set correctly for the unit to
operate to its maximum potential.
The C-Series controllers are equipped with several of these jumpers.
Each are discussed in the appropriate section of this manual. The factory
default settings are shown below.
04C06C,53C
egatloVyrettaB
CDstlov21CDstlov21
RVL/ezilauqE
launaM
noitazilauqE
launaM
noitazilauqE
edoMgnitarepO
lortnoCegrahClortnoCegrahC
Table 5
Factory Default Settings for C-Series Controllers
3.0 INSTALLATION
23
Figure 11
Jumpers
All manuals and user guides at all-guides.com