Xerox 4112 - Page 19

Page 19 Xerox 4127/4112 PDL Reference Guide
Feature Implementation Values
= value
TRAY1: Feed from paper tray1
TRAY2: Tray2
TRAY3: Tray3
TRAY4: Tray4
SMH: Bypass tray
(SMH is abbreviation of special material
handler.)
<ESC>&l int H
Where int is one of the following:
0: Feed paper from default tray
4: Tray1
1: Tray2
5: Tray3
8: Tray4
20: Auto
21: Tray6
22: Tray7
39: Tray8
2 or 3 = Bypass tray
Output
Location
@PJL SET OUTBIN = value Where value is one of the following:
UPPER: Main tray (Hewlett-Packard
compatible)
MAINTRAY: Main tray
MAINTRAY3: finisher top tray (w/
D-Finisher and HCS)
OUTBIN101: Finisher tray (w/ D-Finisher)
OUTBIN104: hcs tray (w/ HCS)
BOOKLETTRAY: booklet tray (w/
D-Finisher and booklet module)
FOLDERTRAY: folder tray (w/ D-Finisher
and folder module)
<ESC>&l int G Where int is one of the following:
0: Automatic Selection
1: Main tray
4: finisher top tray (w/ D-Finisher and HCS)
6: Finisher tray (w/ D-Finisher)
41: hcs tray (w/ HCS)
42: hcs top tray (w/ HCS)
Stapling @PJL SET STAPLE = value Where value is one of the following:
TOPDUAL
TOPLEFT
TOPRIGHT
BOTTOMDUAL
BOTTOMLEFT
BOTTOMRIGHT
LEFTDUAL
RIGHTDUAL
SADDLE
NONE
Punch @PJL SET PUNCH =
value1
Where value1 is one of the following:
TOP
RIGHT
LEFT
BOTTOM