Xerox 4112 - Page 20

Page 20 Xerox 4127/4112 PDL Reference Guide
Feature Implementation Values
@PJL SET JOBATTR
= ”@PNHN = value2”
NONE
Where value2 is one of the following:
TWO: 2 holes
Folding @PJL SET JOBATTR =
"@FOLD = value1"
Where value1 is one of the following:
BIFOLDINSIDE: Bi-Fold Single Sheets
(Print Inside)
BIFOLDMULTIOUTSIDE: Bi-Fold Multiple
Sheets
Booklet @PJL SET JOBATTR =
“@BKLT = value1”
@PJL SET JOBATTR =
“@BKSG = value2”
@PJL SET JOBATTR =
“@BKDN = int1”
Where value1 is one of the following:
NONEDIVIDE: Compile a booklet as long
as the number of sheet does not exceed the
limit
MANUALDIVIDE: Divide sheets based on
the specified limit manually(The number of
sheets is specified with “@BKDN”).
OFF: Do not compile a booklet
Where value2 is one of the following:
RIGHT = Right / Bottom Bind
LEFT = Left / Top Bind
Where int1 is:
1~9999 = Booklet dividing number for each
set
Quantity @PJL SET QTY = int Where int is:
1-999
(If you use this parameter, it also indicate
use collate mode automatically.)
Resolution @PJL SET RESOLUTION =
value
Where value is one of the following:
600
Bits Per Pixel @PJL SET BITSPERPIXEL
= value
Where value is one of the following:
1: 1 bit per pixel (per plane)
Copies @PJL SET COPIES = int Where int is:
1-999
(This parameter used for uncollated mode.)
<ESC>&l int X
Where int is:
1-999
Simplex @PJL SET DUPLEX =
value1
Where value1 is one of the following:
OFF: simplex
<ESC>&l int S
Where int is one of the following:
0: simplex