Xerox 4112 - Page 21

Page 21 Xerox 4127/4112 PDL Reference Guide
Feature Implementation Values
Duplex @PJL SET DUPLEX =
value1
@PJL SET BINDING =
value2
Where value1 is one of the following:
ON: duplex
Where value2 is one of the following:
LONGEDGE
SHORTEDGE
(value2 is used combined with value1=ON)
<ESC>&l int S
Where int is one of the following:
1: Duplex Long Edge Binding
2: Duplex Short Edge Binding
Orientation @PJL SET ORIENTATION
= value
Where value is one of the following:
PORTRAIT
LANDSCAPE
<ESC>&l int O
Where int is one of the following:
0: Portrait
1: Landscape
2: Reverse Portrait
3: Reverse Landscape
Force short
edge feeding
@PJL SET
PAPERDIRECTION = value
Where value is one of the following:
SEF: Short Edge Feed
LEF: Long Edge Feed
Job Mode @PJL JOB MODE = value Where value is one of the following:
PRINTER for Printer
Job Type
(Secure Print /
Proof Print)
@PJL SET HOLD = value1
See Example 3
@PJL SET HOLDKEY ="
four-digit string"
Where value1 is one of the following:
PROOF: proof print
STORE: confidential print (secure
print)
The HOLDKEY variable acts as a password
without encryption to protect a held job.
Four-digit string can be any four-digit value
from 0000 to 9999. The default value is “”.
When “”(null) is specified, no password is
required.
Interleaving
Paper(Transp
arency
Separator)
@PJL SET SLIPSHEET =
value
Where value is one of the following:
OFF: no slipsheet
BLANK: blank slipsheet
COPY: imaged slipsheet
Job Based
Accounting
@PJL SET JOBATTR =
“@JOAU = string1”
@PJL SET JOBATTR =
“@JOAP = string2”
@PJL SET JOBATTR =
Where string1 is a maximum of 32 character
(ASCII characters in the range 20h - 7Eh are
allowedOnly
) as job owner (Capital character & small
character is distinguished)
Where string2 is a maximum of 12 character
(ASCII characters in the range 20h - 7Eh are