Xerox 4800 Series

Xerox Scanner User’s Guide 103
Scanning from the TWAIN Interface
Setting Up PaperPort to Work with Your Scanner
On the PaperPort Scan Pane, when you selected a scanner from
the Available Scanners window, the Scan button at the bottom of
the panel should become active after approximately 5 to 10
seconds. If it doesn’t, you need to set up PaperPort to work with
your scanner.
NOTE: Setting up PaperPort is a one-time-only process for
each option listed in the Available Scanners window.
Therefore, you may have to set up PaperPort once each for
TWAIN and WIA. The setup process is the same for each
option. You will not have to set up PaperPort again unless you
uninstall the scanner and PaperPort software, then re-install
them.
If this Scan button is not active, you need to
set up PaperPort to work with your scanner.