2
Installation Procedure
1. Switch the power off by pressing the power
switch located on the left side of the printer
to the <O> position.
Unplug the power cord from the power
outlet and the printer.
2. Loosen the two screws that secure the rear
cover to the printer.
3. Pull the rear cover forward and remove it
from the printer.
4. Insert the connector on the hard disk into
the connector on the printer (located at the
bottom of the controller board).
Important
• The connector at the center of the controller board is
for a network expansion card. Do not insert the hard
disk into this connector.
5. Push the hard disk by the part shown in the
figure and firmly insert it into the connector.
HDD.fm Page 2 Monday, August 21, 2006 9:37 AM
To Next Page
Loading...
