3
English
6. Secure the hard disk onto the controller
board by tightening the two screws
(supplied) from the outside of the controller
board.
7. Re-attach the rear cover on the printer by
tightening the two screws loosened in Step
2.
8. Plug in the power cord and switch the power on by pressing the power switch to the
<|> position.
The installation is now complete.
Note
• You can check whether the internal hard disk has been installed correctly by printing out the [Printer
Settings] list. Refer to the Quick Reference Guide on how to print the [Printer Settings] list.
HDD.fm Page 3 Monday, August 21, 2006 9:37 AM
To Next Page
Loading...
Need help?
General